At-home testing has never been easier. Begin by registering your BalanceTest ID at () and take a photo of your test code, then perform these following steps.
1. Wash your hands
Wash your hands with soap and warm water.
2. Clean your finger
Clean the tip of your middle finger with the alcohol wipe.
3. Prick your finger
Place the lancet against the lower part of your fingertip. Press firmly until you hear a click.
4. Collect your blood
Without touching the paper, add a minimum of three free dripping blood drops to each circle on the sample card. The blood should completely fill the inner part of the circles.
5. Let dry
Let your sample dry at room temperature for 10 minutes.
6. Place in the bag
Insert the sample card back into the paper envelope and place it into the metal bag. Do not remove the desiccant packet.
7. Post
Put the closed metal bag into the large envelope with the laboratory address on it. Don’t forget the stamps.
Now you’re all done! Don’t forget to post your sample in 1-2 days to ensure its freshness. Register your test ID at() and get a notification when your results are ready, this usually takes 10-20 days.
Choosing a selection results in a full page refresh.
